A DJ set is not a stack of full tracks. Each mix overlaps the end of one track with the start of the next, so the set is shorter than the sum of the track lengths. This page does that arithmetic for you, then gives a lookup table for how long a mix lasts at hard dance tempos.
Method: overlap seconds = bars × 4 beats × 60 ÷ BPM, assuming four beats to a bar. Each track after the first adds (track length − overlap). Set length with N tracks = N × (L − O) + O. Tracks needed = (set length − O) ÷ (L − O). Real sets have intros, outros and edits, so keep a few minutes of margin.
Say you have a 60-minute slot, play tracks that average 5 minutes, and blend for 16 bars at 150 BPM. Sixteen bars at 150 BPM last 25.6 seconds, about 0.43 minutes. Each track after the first therefore adds 5 − 0.43 = 4.57 minutes. The tracks needed are (60 − 0.43) ÷ 4.57, which is 13.03.
That is just over 13, so the planner shows both neighbours. Thirteen tracks run 59 minutes 53 seconds, which is a hair under the slot. Fourteen tracks run 64 minutes 27 seconds, more than four minutes over. For this slot the sensible plan is 13 tracks and a short outro, or 13 tracks with slightly longer overlaps.
Overlap is a trade. A 32-bar blend at 150 BPM lasts 51.2 seconds instead of 25.6, so each track adds about 4.15 minutes instead of 4.57. The same hour then needs 14.3 tracks instead of 13, because every mix reuses more of the previous track’s running time. Doubling the overlap raises the track count by about one in a one-hour set.
The overlap column of the planner uses these numbers. The table is simple arithmetic: seconds = bars × 240 ÷ BPM.
| Bars | 140 BPM | 150 BPM | 155 BPM | 160 BPM |
|---|---|---|---|---|
| 8 | 13.7 s | 12.8 s | 12.4 s | 12.0 s |
| 16 | 27.4 s | 25.6 s | 24.8 s | 24.0 s |
| 32 | 54.9 s | 51.2 s | 49.5 s | 48.0 s |
| 64 | 109.7 s | 102.4 s | 99.4 s | 96.0 s |
A faster tempo makes every mix shorter in real time. A 32-bar blend that lasts almost 55 seconds at 140 BPM lasts 48 seconds at 160 BPM.
The planner needs one tempo. If your set crosses genres, plan each block separately. These are commonly cited ranges for the hard dance styles most sets draw from, as Wikipedia states them. Wikipedia is a secondary source, so treat them as rough guides, not rules.
| Style | Tempo (BPM) | Wikipedia wording |
|---|---|---|
| Jumpstyle | 140–150 | “typically ranges between 140 and 150 BPM” |
| Hard house | 135–165 | “around 150 BPM” but ranges from 135 to 165 |
| Hardstyle | 150–160 | produced around 150 BPM; range moved from 135–150 to 150–160 |
| Gabber | 140–190 | “generally between 140 and 190 beats per minute” |
If the tracks you plan to play differ by many BPM, plan them as separate blocks and add the block lengths together.
Each track after the first adds its length minus the overlap, because the next track starts under the end of the last. With set length T, track length L and overlap O, tracks N = (T − O) ÷ (L − O). The planner does this and shows the set length for the tracks on either side of the answer.
One bar of four beats lasts 4 × 60 ÷ 150 = 1.6 seconds, so 16 bars last 25.6 seconds. At 160 BPM the same 16 bars last 24 seconds.
Real tracks vary in length, so a whole number of identical tracks rarely hits your set length exactly. The planner shows the decimal result, then the length you get with the number of tracks just below and just above it.
No. It is a planning calculator only. It does not list artists, releases or events.
Bizerk is an independent informational site with a DJ set planning calculator. It sells nothing, takes no advertising and is not an artist, booking or label page. The tempo ranges are commonly cited figures from the Wikipedia articles on jumpstyle, hard house, hardstyle and gabber, a secondary source. The rest is arithmetic you can check by hand. Last reviewed: November 2026.